What about using with .NET Gadgeteer FEZ Cerberus?

Nov 23, 2012 at 4:57 PM

ehy there is a chance to setup Visual Studio to use in a easy way the ENC28 GHI Module attacched to a FEZ Cerberus?

 

There is any step by step instructions?

Jan 20, 2013 at 7:18 PM

You can do it, you just don't add it to the designer.  Plug it into Socket 6 and it works.  If it is a Gadgeteer project remove the infinite wait since Gadgeteer doesn't need the infinite wait.

Dec 4, 2013 at 10:29 AM
Also, I think you need to make sure that you DON'T have the ethernet firmware installed on the Cerberus, as this is being handled for you by mIP.
Dec 7, 2013 at 7:45 PM
I have a Cerberus board running with this managed Network stack using the following steps:
  • Installed the non Ethernet Cerberus firmware
  • connected components making sure the ENC28 is connected to port 6
  • use the designer to assign all components except the Ethernet module
  • used code from the samples to setup the connection.
  • make sure to adjust the code to contect with the correct hardware enum value